Re-engineering the manufacturing system
Stein, Robert E.
Reading Time
at 250 WPM6h 3m
The average reader, reading at a speed of 250 WPM, would take 6h 3m to read Re-engineering the manufacturing system.
Personalise your estimate by entering your reading speed below
Test my reading speedEnter speed in words per minute
13
days at 30 min/day
363
total minutes
Re-engineering the manufacturing system
Published
2003
Publisher
M. Dekker
Pages
363
ISBN-10
0824742656
Description
An information systems trailblazer in the domains of decision support and factory and supply chain synchronization, the Second Edition of Re-Engineering the Manufacturing System: Applying the Theory of Constraints stays true to its title, once again bestowing uniquely straightforward instructions for designing, installing, and operating manufacturing information systems. This updated and expanded source takes special care to clarify the often blurred concepts of synchronization and optimization, plus offers implementation advice from four discrete angles to yield better bottom-line results.
Subjects
Frequently Asked Questions
How many pages are in Re-engineering the manufacturing system?
This edition of Re-engineering the manufacturing system has approximately 363 pages. Please note, this is an estimate and the exact page count can vary between hardcover, paperback, and e-book versions.
How long does it take to read Re-engineering the manufacturing system?
For most readers, Re-engineering the manufacturing system typically takes between 7h 34m and 5h 3m to complete. This is based on the book's length of approximately 90,750 words and common reading speeds.
Here's a detailed breakdown: • Continuous reading at 250 WPM: approximately 6h 3m of focused reading • Casual reading (30 minutes/day): you could finish in roughly 13 days • Estimated word count: 90,750 words
Your individual reading time will vary based on your personal reading pace, the amount of daily reading time, and your familiarity with the subject matter.
What is the word count of Re-engineering the manufacturing system?
The estimated word count for Re-engineering the manufacturing system is approximately 90,750 words. This figure is calculated using industry-standard methods that consider genre-specific word density patterns, typical formatting and layout characteristics, and standard words-per-page ratios for published books.
This is an approximation — actual word count may vary based on font size, formatting, edition, and the presence of illustrations or charts.
Who is the author of Re-engineering the manufacturing system?
Re-engineering the manufacturing system was written by Stein, Robert E..
When was Re-engineering the manufacturing system published?
The publication date for this specific edition is 2003. The original work may have been published on a different date.