Pressure probes at very low density
K. R. Enkenhus
Reading Time
at 250 WPM1h 6m
The average reader, reading at a speed of 250 WPM, would take 1h 6m to read Pressure probes at very low density.
Personalise your estimate by entering your reading speed below
Test my reading speedEnter speed in words per minute
3
days at 30 min/day
66
total minutes
Pressure probes at very low density
Published
1957
Publisher
Institute of Aerophysics
Pages
66
Free molecular flow into a convergent cone at orbital velocity
Pressure measurement in transition and free molecular flows using orifice probes
Free-molecule flow through axi-symmetric tubes
Recent trends in the mechanics of highly rarefied gases
Transport properties of free-molecule (Knudsen) flow
Subsonic tests in free molecule flow on impact tube pressure probes having a wide range of tube lengths at angles of attack up to 90 degrees
Frequently Asked Questions
How many pages are in Pressure probes at very low density?
This edition of Pressure probes at very low density has approximately 66 pages. Please note, this is an estimate and the exact page count can vary between hardcover, paperback, and e-book versions.
How long does it take to read Pressure probes at very low density?
For most readers, Pressure probes at very low density typically takes between 1h 23m and 55m to complete. This is based on the book's length of approximately 16,500 words and common reading speeds.
Here's a detailed breakdown: • Continuous reading at 250 WPM: approximately 1h 6m of focused reading • Casual reading (30 minutes/day): you could finish in roughly 3 days • Estimated word count: 16,500 words
Your individual reading time will vary based on your personal reading pace, the amount of daily reading time, and your familiarity with the subject matter.
What is the word count of Pressure probes at very low density?
The estimated word count for Pressure probes at very low density is approximately 16,500 words. This figure is calculated using industry-standard methods that consider genre-specific word density patterns, typical formatting and layout characteristics, and standard words-per-page ratios for published books.
This is an approximation — actual word count may vary based on font size, formatting, edition, and the presence of illustrations or charts.
Who is the author of Pressure probes at very low density?
Pressure probes at very low density was written by K. R. Enkenhus.
When was Pressure probes at very low density published?
The publication date for this specific edition is 1957. The original work may have been published on a different date.