Laser in der Produktion
Hans-Jürgen Warnecke
Reading Time
at 250 WPM1 minute
The average reader, reading at a speed of 250 WPM, would take 1 minute to read Laser in der Produktion.
Personalise your estimate by entering your reading speed below
Test my reading speedEnter speed in words per minute
1
day at 30 min/day
1
total minutes
Laser in der Produktion
Published
1988
Publisher
Springer Berlin Heidelberg
Pages
1
ISBN-13
9783642836374
ISBN-10
3642836372
Description
Bis zur breiten industriellen Anwendung dieses neuen Werkzeuges mußte die Lasertechnologie verschiedene wechselhafte Phasen durchlaufen. Erst in den letzten fünf Jahren konnte sich der Laser in verschiedenen Anwendungsgebieten durchsetzen. Ziel dieser Tagung war die praxisnahe Darstellung der vielfältigen Anwendungsmöglichkeiten des Lasers in der industriellen Fertigungstechnik. Weiterhin sollten Erfahrungen und neue Erkenntnisse auf diesem innovativen und sich rasch entwickelnden Gebiet vermittelt werden. Den inhaltlichen Schwerpunkt bilden traditionsgemäß technologische und anwendungsbezogene Aspekte der Materialbearbeitung mit Lasern. In ihrer strukturellen Gestaltung orientierte sich die Konferenz daher sehr stark an Problemstellungen, die für den industriellen Anwender dieser Technologie von Bedeutung sind. Neben dem Laserstrahl-Schneiden und -Schweißen sowie der Oberflächenbehandlung von Werkstücken mit dem "thermischen Werkzeug Laserstrahl" werden Handhabungstechniken und Verfahren der Prozeßkontrolle und -steuerung vorgestellt.
Subjects
Experimental confirmation of a PDE-based approach to design of feedback controls
Social theory for a changing society
Structuralisme
Male Domination
Analysis of remote operating systems for space-based operations, final report
Intelligent structural systems
Frequently Asked Questions
How many pages are in Laser in der Produktion?
This edition of Laser in der Produktion has approximately 1 pages. Please note, this is an estimate and the exact page count can vary between hardcover, paperback, and e-book versions.
How long does it take to read Laser in der Produktion?
For most readers, Laser in der Produktion typically takes between 1m and 1m to complete. This is based on the book's length of approximately 250 words and common reading speeds.
Here's a detailed breakdown: • Continuous reading at 250 WPM: approximately 1m of focused reading • Casual reading (30 minutes/day): you could finish in roughly 1 day • Estimated word count: 250 words
Your individual reading time will vary based on your personal reading pace, the amount of daily reading time, and your familiarity with the subject matter.
What is the word count of Laser in der Produktion?
The estimated word count for Laser in der Produktion is approximately 250 words. This figure is calculated using industry-standard methods that consider genre-specific word density patterns, typical formatting and layout characteristics, and standard words-per-page ratios for published books.
This is an approximation — actual word count may vary based on font size, formatting, edition, and the presence of illustrations or charts.
Who is the author of Laser in der Produktion?
Laser in der Produktion was written by Hans-Jürgen Warnecke.
When was Laser in der Produktion published?
The publication date for this specific edition is 1988. The original work may have been published on a different date.