Drying in the process industry
C. M. van't Land
Reading Time
at 250 WPM6h 21m
The average reader, reading at a speed of 250 WPM, would take 6h 21m to read Drying in the process industry.
Personalise your estimate by entering your reading speed below
Test my reading speedEnter speed in words per minute
13
days at 30 min/day
381
total minutes
Drying in the process industry
Published
2012
Publisher
John Wiley & Sons
Pages
381
ISBN-13
9780470131176
ISBN-10
0470131179
Description
"This book assists the process development engineer, the process engineer, and the plant engineer in selecting drying equipment. The criteria to be observed are discussed. The procedure concerning the selection of an industrial dryer always starts with the gathering of results of relevant laboratory measurements. The next step is carrying out small-scale tests, the results of which can be scaled up. Procedures for sizing equipment are also covered. Written by an author with over four decades in the process industries, this book brings an extensively practical approach for the engineer"--
Solutions manual to accompany Applied mathematics and modeling for chemical engineers
Dryden's Outlines of Chemical Technology for the 21st Century
Chemical Reactor Design for Process Plants
Encyclopedia of Chemical Processing and Design
Principles of unit operations
Elementary principles of chemical processes
Frequently Asked Questions
How many pages are in Drying in the process industry?
This edition of Drying in the process industry has approximately 381 pages. Please note, this is an estimate and the exact page count can vary between hardcover, paperback, and e-book versions.
How long does it take to read Drying in the process industry?
For most readers, Drying in the process industry typically takes between 7h 56m and 5h 18m to complete. This is based on the book's length of approximately 95,250 words and common reading speeds.
Here's a detailed breakdown: • Continuous reading at 250 WPM: approximately 6h 21m of focused reading • Casual reading (30 minutes/day): you could finish in roughly 13 days • Estimated word count: 95,250 words
Your individual reading time will vary based on your personal reading pace, the amount of daily reading time, and your familiarity with the subject matter.
What is the word count of Drying in the process industry?
The estimated word count for Drying in the process industry is approximately 95,250 words. This figure is calculated using industry-standard methods that consider genre-specific word density patterns, typical formatting and layout characteristics, and standard words-per-page ratios for published books.
This is an approximation — actual word count may vary based on font size, formatting, edition, and the presence of illustrations or charts.
Who is the author of Drying in the process industry?
Drying in the process industry was written by C. M. van't Land.
When was Drying in the process industry published?
The publication date for this specific edition is 2012. The original work may have been published on a different date.